VEVOR Annular Cutter Set — 13-Piece Weldon Shank, 1" Depth (7/16"–1-1/16")

Drilling clean holes through structural steel with a twist bit is a slow, frustrating exercise — work hardening, chatter, broken bits, and holes that aren't quite round. Annular cutters skip all of that. They cut a ring instead of a slug, so they remove less material, run cooler, and produce a clean, accurate hole in one pass. With a mag drill and the right cutter set, a 3/4" hole through 1/4" plate takes under a minute.

This VEVOR 13-piece annular cutter set covers 7/16" through 1-1/16" in eleven sizes, made from M2AL high-speed steel hardened to HRC 62.5–67.5. That's the alloy and hardness spec you'd see on industrial annular cutters — not vague "high-speed steel" with no further detail.

What's in the set

• 11 Weldon shank annular cutters: 7/16", 1/2", 9/16", 5/8", 11/16", 3/4", 13/16", 7/8", 15/16", 1", 1-1/16"
• Cutting depth: 1" (25mm)
• Blade length including shank: 2.42" (61.5mm)
• Material: M2AL HSS, HRC 62.5–67.5
• Shank type: 3/4" Weldon — fits most magnetic drill bases
• 2 pilot pins: 4.74mm × 77mm and 6.35mm × 77mm
• Hex wrench and foam-lined portable case included
• Net weight: 3.15 lbs (1.43 kg)

Good for

• Structural steel fabrication — beams, angle iron, plate, tube
• Drilling bolt holes in steel without a drill press
• Site work where the mag drill goes to the workpiece, not the other way around
• Anyone who's burned through twist bits trying to drill mild steel and is done with that

Not for

• Wood, drywall, or masonry — wrong tool entirely
• Holes deeper than 1": the 2" depth set is the one you want for thicker stock.
  → VEVOR Annular Cutter Set — 13-Piece, 2" Depth
• Handheld drills without a magnetic base — these need the stability of a mag drill to cut clean.
  → VEVOR Magnetic Drill 1550W — 2" Bore, 11-Piece Kit

Eleven sizes, M2AL HSS. If your hole sizes are in the 7/16"–1-1/16" range and your stock is under 1" thick, this is the set to buy.